Puffco prides itself in creating the finest, most innovating vape hardware on the market today. The Peak was the first in the line in their catalog of groundbreaking e-rigs, still proving itself to be just as impressive today as it was upon its release. It revolutionized portable and desktop concentrate consumption with its stylish design, fantastic vapor quality, and its ability to function both on the go and at home expertly.
Disassembling The Puffco Peak
It’s important to perform a deep, thorough clean to get the Peak back to a flawless condition. To do this you’ll want to disassemble it completely so each element gets cleaned individually.
Firstly, you’ll need to remove the chamber from the unit. This is super simple and can be done by unscrewing in a counter-clockwise rotation from the base. Once this is done it’s advisable to also remove the glass carb cap from the black rubber insert.
Finally, proceed to remove the hand-blown glass water bubbler from the base of the Peak by gently rocking it back and forth while pulling it away until it disconnects.
Cleaning The Chamber
Now that the chamber and glass carb cap has been removed from the base it is time for cleaning.
To deep clean the chamber and carb cap, you’ll need a bowl, isopropyl alcohol, and warm water. Place the chamber and carb cap in a bowl and allow them to soak in the alcohol until all residue has been dislodged from the parts. You will see that it is cleaning when the alcohol begins to turn a yellowish color.
Alternatively, you can also use isopropyl-soaked cleaning swabs to wipe any residue from the atomizer. Once allowed to soak properly, rinse off each element of the Peak with warm water before setting them aside to dry.
Cleaning The Glass Bubbler
Once you’ve removed the glass bubbler from the base of the Peak you’ll want to empty any remaining dirty water. Now it’s time to fill the bubbler approximately ⅓ of the way up with isopropyl alcohol.
Once filled, place your finger at the top by the mouthpiece to stop the alcohol from exiting the bubbler and shake. Just like with the chamber, you’ll need to completely rinse the water bubbler with warm water and allow it to dry before reassembling the unit.
Reassembling The Puffco Peak
The Puffco Peak is as easy to reassemble as it was is take apart.
It’s recommended to begin with the atomizer. Place the clean atomizer back inside the rubber ring and place it back onto the unit, screwing it to keep it in place.
Next, fill the water bubbler with water. There are two internal air holes that are visible inside the bubbler, and water should be filled to submerge them. The bubbler can be pushed lightly to secure it back onto the base of the Peak, at which point it’s ready to vape again.
The Puffco Peak is one of the first of a new wave of devices that bring the power of a dab rig together with the convenience of a vape.